Hello everyone

Guys, please tell me what I'm doing wrong

I installed the EBCM unit from another car on the 2018 eqinox, changed the VIN pin, and there is still a malfunction in the EBCM B3902

Thanks advance

Hi, have you tried recalibrating the ebcm via GM SPS service under setup and configuration then erase the dtc via GDS2?

39 minutes ago, Troy said:

Привет, вы пробовали перекалибровать ebcm через службу GM SPS в настройках и конфигурации, а затем стереть код неисправности через GDS2 ?

yes I tried it, it says you have the latest calibration

16 minutes ago, vavan said:

yes I tried it, it says you have the latest calibration

Not program calibration files. SPS Setup and configuration.

Select: Setup

yes I tried but during setup and configuration there is a loss of connection with ebcm

I'll try again in half an hour

Pin change procedure was not done correctly

I changed the pin using troy file

I know bro , but seems u did mistake somewhere

B3902-00

Wrong Immobiliser Identifier recieved

Or

Possibly any other module is involved

After changed the vin and pin you tried to delete and program the key again?

yes I tried

B3902-00 means Wrong Immobiliser Identifier received:

3 hours ago, Troy said:

Not program calibration files. SPS Setup and configuration.

Select: Setup

I meant electron brake control module (ebcm) and not bcm

your pin does not match the car. you need to unlink the unit and then program it into your car.

37 minutes ago, T_Ivan said:

your pin does not match the car. you need to unlink the unit and then program it into your car.

Thanks

but pin corresponds.

I'll try to do it tomorrow as recommended by troy, with sps

Sorry, I originally thought the EBCM was still malfunction after replacing it. That DTC error appears whenever you replace a module that’s part of the vehicle secured system with a used module, for example the IPC, EBCM, BCM etc. The used EBCM still has the other vehicle’s security blob code programmed on to it. You need to remove and reprogram the vehicle keys to get rid of that DTC error

The article below have more information about the modules that store a PIN and how to remove that DTC error.

 

 

Exactly, that's what i said earlier

Hello everyone

Forgot to say

There is still a U0420 fault in the ebcm (the data received from the PSCM is incorrect), and the ebcm unit does not see the steering angle sensor, so I decided that I need to program the pin and vin in the used ebcm

in this case the steering angle sensor is visible in the PSCM

BRO ALLOW ME TO HELP YOU

send me Anydesk in PM

Sorry bro I'm not near the car now

If it's possible I'll let you know at 18-18:30

2 minutes ago, vavan said:

Sorry bro I'm not near the car now

If it's possible I'll let you know at 18-18:30

I need sps access

So that I can enable it by this time