is possible program the bcm on bench with dps?? if it is possible wichc is pinout?? i try using pinout from ioterminal but not conect to the bcm.

 

thanks

 

jorge costa

Works fine for me.

 

But I haven't tried DPS yet. For the cloning is OK.

Hi,

if you want to connect to BCM on bench with MDI2 or similar, you have to add 120 Ohms resistance between CANH and CANL.

I had the same...

 

Greetings,

 

Toby

I try tobflash the bcm in the car but with error

tility File Step=0D Opcode=B0 Downloading CAL File:  13522386.01.BIN   17:44:50.259<[.H..] 00 00 02 41 36 00 FE DF 00 00 7C 4D 00 01 23 28 00 CE 55 D2 43 57 00 1F .. [4090] FramePad   17:44:50.995>[.H..] 00 00 02 41 [0004] TxDone TxMsgType   17:44:50.997>[.H..] 00 00 06 41 7F 36 78 [0007] PaddingError   17:44:51.041>[.H..] 00 00 06 41 7F 36 78 [0007] PaddingError   17:44:51.080>[.H..] 00 00 06 41 7F 36 78 [0007] PaddingError   17:44:51.088>[.H..] 00 00 06 41 7F 36 78 [0007] PaddingError   17:44:51.096>[.H..] 00 00 06 41 7F 36 78 [0007] PaddingError 

 

any on can tell me qhy have those error??

Your frames should be padded with 0-s if the length is smaller than 8 bytes. I dont know why this is happening.