24 minutes ago, Selektion Automotive said:

@Arbe_gtc 2 questions..

 

Can you show how you made the connections in Red and Blue circles?
 

"17 0.35 PK 1139 Ignition 1 Voltage"

When you say this connection is it a normal 12v connection?  

blue circle cables unconnected

Red, positive and negative.

12 volts. nothing special

11 hours ago, Selektion Automotive said:

So basically it's a homemade breakout cable?

 

 

yes, you go o the scrapyard, cut the wires in the SDM module, and use in home.
I think the small connector is the same in ALL GM SDM units, the big connector changes.

I have a Insignia A and Astra K SDM and the small connector, matches. the big connector is different.

The OBD port its from Astra H

5 hours ago, Arbe_gtc said:

yes, you go o the scrapyard, cut the wires in the SDM module, and use in home.
I think the small connector is the same in ALL GM SDM units, the big connector changes.

I have a Insignia A and Astra K SDM and the small connector, matches. the big connector is different.

 

The OBD port its from Astra H

 

Soon full bench setup

did you wire white/blue cable to serial data communications?by my diagramsSDM require HI can plus serial data enable wire.

@vladimius

@vladimius u have to get wake up device, like bcm.

@Selektion Automotivesee attached pdf diagrams, in instance to woke up module and allow to communicate you need to sent signal to it. Other way will see module in gds/dps, but will not allow you programming. Not yet tested on SDM as waiting to get one in my hands, but ECM not allow programming until signal been sent to it.

Communication Enable (1 of 2).pdf Communication Enable (2 of 2).pdf

19 hours ago, FIXCAR GABRIEL said:

HI GLOBAL B POSSIBLE VIN E PIN CHANGE

Sure